How to Maintain Your Roll Laminator

Your roll laminator is an important piece of machinery. Chances are you use it regularly to laminate a wide variety of items including maps, posters, and retail displays. It’s important that you properly maintain your device so you can get the most out of it. Here is how you can maintain your roll laminator:


  • First of all, you will want to keep the machine’s rollers in good shape. You can do this by cleaning them. Cleaning the rollers will get rid of any adhesive that may be stuck to them. If adhesive builds up over time, it can cause a variety of problems. In order to clean your rollers, just follow these steps:

    • Remove any laminating film that’s still installed. Since this can be difficult to do, you might want to wait until you’re out of film to clean the rollers.


    • Let the laminator warm up a bit. This will soften the adhesive and make it easier to remove.


    • Grab a soft scrubbing pad that doesn’t contain steel and begin scrubbing the rollers. Make sure you exercise caution while doing this as the rollers will be pretty warm. You might find that it takes a while to remove all the adhesive, so just be patient and you’ll be able to finish the job.


    • Install a new roll of laminating film. (Or re-install the old roll.) You can then go on laminating as you normally would.




  • Also in regard to the rollers, make sure you never use any sharp objects around them. This includes scissors and craft knives. Sharp objects can severely damage the silicone that coats the rollers which can lead to you needing to repair or even replace the machine. Do yourself a favor and keep the sharp objects away from your laminator.


  • Make sure you use the right supplies with your machine. That includes using laminating film that’s compatible with the device. Pay attention to laminating film thickness which is measured in mils. (A mil is 0.001th of an inch.) Don’t use film that’s too thick or thin for your machine. Also, don’t use mounting boards if your machine can’t handle them. This can cause problems with the device.


  • This should almost go without saying, but it’s important to turn off your laminator when you’re done using it. If the laminator is left on for too long, there is a chance that the motor will overheat, which is usually the kiss of death for the machine. Also, turning the device off will conserve power and reduce the risk of fire and injury.


  • Finally, read your laminator’s instruction manual and don’t be afraid to call in a professional if the need arises. If you don’t know how to solve a problem with your device, a professional will be able to fix things without voiding your warranty.



Maintaining your roll laminator is important and it really isn’t too difficult to do. Just follow the above tips so you can keep your machine in good shape. Good luck!

The Article Source

Leave a Reply

Your email address will not be published. Required fields are marked *